Coffeemaker User Manual

GNS 530(A) Pilot’s Guide and Reference
190-00181-00 Rev. E
10-23
SECTION 10
AUX PAGES
Changing the ILS CDI scale:
1) Select ‘CDI/Alarms’ from the Setup Page, using
the steps described at the beginning of this
section.
2) Turn the large
right knob to highlight the ‘ILS
CDI Capture’ field.
3) Turn the small
right knob to select ‘Auto’ or
‘Manual’ as desired (Figure 10-34). Press the
ENT Key to accept the selection.
Figure 10-34 ILS CDI Window
Setting the arrival alarm and alarm
distance:
1) Select ‘CDI/Alarms’ from the Setup Page, using
the steps described at the beginning of this
section.
2) Turn the large right knob to highlight the
‘On’/’Off’ field (directly below ‘Arrival Alarm’).
3) Turn the small right knob to select ‘On’ or
‘Off’, as desired. Press the
ENT Key to accept
the selection.
4) The flashing cursor moves to the alarm distance
field (to the immediate right of ‘On’ or ‘Off’).
To enter an arrival alarm distance, use the small
and large right knobs to enter the desired
alarm distance. Press the ENT Key when
finished.
NOTE: The CDI scale is always measured in
nautical miles, regardless of the current distance
units of measure selected on the Units/Position
Page.