Two-Way Radio User Manual

MAP SOLUTION

13.1

MAP SOLUTION: Map a solution from an old mesh to a new mesh.

This option is used to transfer solution variables from an earlier analysis to a new mesh that occupies the sam e

space.

Product: ABAQUS/Standard

Type: Model data

Level: Model

Reference:

•

“Mesh-to-mesh solution mapping,” Section 12.4.1 of the ABAQUS Analysis User ’s Manual

Optional parameters:

INC

Set this parameter equal to the increment number from which the old solution will be read. If this

parameter is omitted, the last increment for which a solution is available will be read.

The STEP parameter must be speciﬁed if the INC parameter is used.

STEP

Set this parameter equal to the step number from which the old solution will be read. If this

parameter is omitted, the last ste p and increment for which a solution is available will be read.

UNBALANCED STRESS

Set UN BALAN CED STRESS=RAMP (default) if the stress unbalance is to be resolved linearly

over the step.

Set UNBALANC ED STRESS=STEP if the stress unbalance is to be resolved in the ﬁrst

increment.

Data line to translate an old-model mesh:

First (and only) line:

1. Value of the translation to be applied in the X-direction.

2. Value of the translation to be applied in the Y-direction.

3. Value of the translation to be applied in the Z-direction.

Data lines to translate and/or rotate an old-model mesh:

First line:

1. Value of the translation to be applied in the X-direction.

13.1–1

ABAQUS Version 6.1 Module:

ID:

Printed on: