Two-Way Radio User Manual

*
NMAP
3. Y-coordinate of the point to which this control node is to be mapped.
4. Z-coordinate of the point to which this control node is to be mapp ed.
Second line:
1. Node number of the second control node.
2. X-coordinate of the point to which this control node is to be mapped.
3. Y-coordinate of the point to which this control node is to be mapped.
4. Z-coordinate of the point to which this control node is to be mapp ed.
Continue, giving up to 20 control nodes, but giving at least the eight corner nodes. If an edge of the
blended mapping is to be mapped linearly, the corresponding mid-edge control node can be omitted from
the list. This is done by inser ting a line with node number 0 only (a blank line) in place of the definition
of the control node and its mapped coordinates. The control nodes do not have to be nodes in the finite
element model—they can be nodes used just for mesh generation. ABAQUS eliminates any nodes that
are not used in the analysis model before doing the analysis.
14.4–3
ABAQUS Version 6.1 Module:
ID:
Printed on: