Two-Way Radio User Manual

*
REBAR
Optional parameters:
GEOMETRY
This parameter is not meaningful for rebar in beams, axisymm etric shells, or axisymmetric
membranes, or for single rebar i n conti nuum elements.
Set GEO METRY=ISOPARA METRIC (default) to indicate that the layer of rebar is parallel to
a direction of the element local (isoparametric) coordinate system.
Set GEOMETRY=SKEW to indicate that the rebar layer is in a skew direction with respect to
the element faces.
ISODIRECTION
Set this parameter equal to the isoparametric direction from which the rebar angle output will be
measured. The default is 1.
ORIENTATION
This parameter is m eaningful only for skew rebar in shell and mem brane elements. Set this
parameter equal to the name of an orientation definition that defines the angular orientation of
the rebar. This param eter is not permitted with axisymmetric shell and axisymmetric mem brane
elements.
SINGLE
This parameter is meaningful only for continuu m elements. Include this parame ter if a single rebar
is being defined by each data line. If this parameter is omitted, each line defines a layer of uniformly
spaced rebar in the element isoparametric space.
Data lines to define rebar in beam elements:
First line:
1. Element number or name of the element set that contains these rebar.
2. Cross-sectional area of the rebar.
3. Distance
(see Figure 17.10–1).
4. Distance
.
Repeat this data line as often as necessary. Each line defines a single rebar.
17.10–2
ABAQUS Version 6.1 Module:
ID:
Printed on: