Two-Way Radio User Manual

ManualsBrands3D Connexion ManualsTwo-Way RadioKeywords Reference Manual: Volume II Version 6.6

351

352

353

354

355

356

357

358

359

360

RESTART

If this parameter is omitted, the restart will begin at the end of the step speciﬁed on the STEP

parameter.

ITERATION

If the new analysis is restarted from a previous direct cyclic analysis, set this param eter equal to the

iteration number within the speciﬁed step of the direct cyclic analysis after which the analysis will

resume. Since the new analysis can be restarted only from the end of a loading cycle in the previous

direct cyclic analysis, the INC parameter is irrelevant and is ignored if the ITERATION parameter

is speciﬁed.

If this parameter is omitte d, the restart will begin at the end of the last iteration for the speciﬁed

step.

STEP

Set this parameter equal to the step number at which the restart will be m ade.

If this parameter is omitted, the analysis will restart at the last available step found.

Optional parameters if the W RITE parameter is used:

FREQUENCY

This parameter speciﬁes the increments at which restart information will be written. For exam ple,

FREQUENCY=2 will write restart information at increments 2, 4, 6, etc. For a direct cyclic analysis

this parameter speciﬁes the iteration numbers at which restart information will be written; restart

information will be written only at the end of an iteration. When restart is requested in an analysis,

restart information is always written at the end of a step. Set FREQU ENCY=0 to discontinue the

writing of restart data.

The FREQUENCY and N UMBER INTERVAL parameters are m utually exclusive. The

default is FREQUENCY=1.

NUMBER INTERVAL

Set this parameter equal to the number of intervals during the step at which the

RESTA RT data

are to be written. The value of this parameter must be a positive integer.

The FREQUENCY and N UMBER INTERVAL parameters are m utually exclusive. The

default is FREQUENCY=1.

TIME MARKS

Set TIME MARKS=YES (default) to write results at the exact times dictated by the NUMBER

INTERVAL param eter.

Set TIME MARKS=NO to write the restart at the increment ending immediately after the time

dictated by the NUM BER INTERVAL parameter.

OVERLAY

This parameter speciﬁes that only one increment should be retained per step, thus m inim izing the

storage space needed.

17.15–2

ABAQUS Version 6.1 Module:

ID:

Printed on: