Two-Way Radio User Manual

ManualsBrands3D Connexion ManualsTwo-Way RadioKeywords Reference Manual: Volume II Version 6.6

361

362

363

364

365

366

367

368

369

370

RESTART

When the OVERLAY parameter is included, each increment w ritten overlays the previous

increment, if any, writ ten for the same step. If this par ameter is omitted, data are ret ained for every

increment. In either case the last increm ent of every step is retained.

There are no data lines associated with this option.

Using

RESTART in an ABAQUS/Explicit analysis

Reference:

•

“Restarting an analysis,” Section 9.1.1 of the A BAQ US Analysis User’s Manual

At least one of the following parameters is required:

READ

Include this parameter to specify that this analysis is a restart of a previous analysis. The basic

model deﬁnition data (elements, materials, nodes) cannot be changed at such a restart. However,

element sets, node sets, and

AMPLITUDE tables can be added, and history data subsequent to that

part of the history already analyzed can be changed.

WRITE

Include this parameter to specify that restart data are to be written during the analysis.

Required parameter if the READ parameter is used:

STEP

Set this parameter equal to the step number at which the restart will be made. If the END STEP and

INTERVAL parameters are omitted, the analysis will resume after the last interval available in this

step.

Optional parameters if the R EAD parameter is used:

END STEP

Include this parameter to specify that the current step should be terminated at this point. The

INTERVAL param eter is required when this param eter is used.

This parameter is useful wh en the user wishes to redeﬁne the l oading history, contact su rface

deﬁnitions, etc.

If this parameter is omitted, ABAQUS/Explicit will continue the analysis from the last

available restart interval to complete the current s tep as it is deﬁned in the run from which the

restart is being m ade.

INTERVAL

Set this parameter equal to the interval number within the step speciﬁed by the STEP param eter

after which the analysis will resume. The END STEP parameter is required when this parameter is

used.

17.15–3

ABAQUS Version 6.1 Module:

ID:

Printed on: