Two-Way Radio User Manual

*
RESTART
Optional parameters if the W RITE parameter is used:
NUMBER INTERVAL
Set this parameter equal to the number of intervals during the step at which the
*
RESTA RT data
are to be written. The value of this parameter must be a positive integer. The default is NUMBER
INTERVAL=1.
ABAQUS/Explicit will always write the restart data at the beginning and end of the step. For
example, if NUMBER INTERVA L=10, ABAQUS/Explicit will write 11 restart states, consisting
of the values at the beginning of the step and the values at 10 evenly spaced intervals throughout
the step.
TIME MARKS
Set TIME MARKS=NO (default) to write the restart at the increment ending im mediately after the
time dictated by the NUMBER INTERVAL parameter.
Set TIME MARK S=YES to write results at the exact tim es dictated by the NUMBER
INTERVAL parameter. TIME MARKS=YES cannot be used when either the FIXED TIME
INCREMENTATION or DIRECT USER CONTROL parameter is included on the
*
DYNAMIC
option (“Explicit dynamic analysis,” Sectio n 6.3.3 of the ABAQUS Analysis User’s Manual).
OVERLAY
This parameter specifies that only one increment should be retained per step, thus m inim izing the
storage space needed.
When the OVERLAY parameter is included, each increment w ritten overlays the previous
increment, if any, written for the same step. If this parameter is omitted, every increment is retained.
In either case the last increm ent of every step is retained.
There are no data lines associated with this option.
17.15–4
ABAQUS Version 6.1 Module:
ID:
Printed on: