Two-Way Radio User Manual

*
SLIDE LINE
18.19
*
SLIDE LINE: Specify slide line surfaces on which deformable structures may
intera ct.
This option is relevant only for slide line and tube-to-tube contact elements. It is used to define the slide line
and to specify which set of contact elem ents interacts with it.
Product: ABAQUS/Standard
Type: Model data
Level: Assembly
References:
•
“Tube-to-tube contact elements,” Section 31.3.1 of the ABA QUS Analysis User ’s Manual
•
“Slide line contact elements,” Section 31.4.1 of the ABAQUS Analysis User’s Manual
Required parameters:
ELSET
Set this parameter equa l to the name of the eleme nt set containing the slide line or tube-to-tube
contact elements that interact with the slide line being defined.
TYPE
Set TYPE=LINEAR to define a slide line made up of linear segments. This param eter should be
used when first-order elements make up the model.
Set TYPE=PARABOLIC to define a slide line made up of parabo lic segments. This parameter
should be used when second-order elements make up the model. In this case the slide line should
consist of an odd number of nodes, where the odd nodes on the slide line are associated with the
ends of parabolic segments.
Optional parameters:
EXTENSION ZONE
Set this parameter equal to a fraction of the end segment length by which either end of an open slide
line is to be extended to avoid numerical round off errors associated with contact modeling. The
value given must lie between 0.0 and 0.2. The default value is 0.1.
GENERATE
Include this parameter to allow incremental generation of node num bers along a slide line.
18.19–1
ABAQUS Version 6.1 Module:
ID:
Printed on: