Two-Way Radio User Manual

*
SURFACE PROPERTY ASSIGNMENT
18.51
*
SURFACE PROPERTY ASSIGNMENT: Assign surface properties to a surface for the
general contact algorithm.
This option is used to modify surface properties for surfaces that are involved in general contact interactions
in ABAQUS/Explicit. It must be us ed in conjunction with the
*
CONTACT option.
Product: ABAQUS/Explicit
Type: Model or history data
Level: Model, Step
References:
•
“Surface properties for general contact,” Section 29.3.2 of the ABAQUS Analysis User’s Manual
• *
CONTACT
Required parameter:
PROPERTY
Use this parameter to specify the property type being assigned. To m odify more than one type of
surface property, use this option m ore than once with different values for the PROPERTY param eter.
Set PROPERTY=FEATURE EDGE CRITERIA to control w hich feature edges should be
activated in the general contact dom ain.
Set PROPERTY=OFFSET FRACTION to assign the surface offset as a fraction of the surface
thickness.
Set PROPERTY=THICKNESS to assign the surface thickness.
Data lines for PROPERTY=FEATURE EDGE CRITERIA:
First line:
1. Surface name. A non-blank surface name is required if the ALL EDGES or PICKED EDGES
options are specified. If the surface nam e is om itted when using the PERIMETER EDG ES,
NO FEATURE EDGES, or cutoff feature angle options, a default surface that encompasses the
entire general contact domain is assu med.
2. The “words” PERIMETER EDGES (default), the “words” ALL EDGES, the “words” PICKED
EDGES, the “words” NO FEATURE ED GES, or a scalar value representing the cutoff feature
angle (in degrees).
Repeat this data line as often as necessar y. If the feature edge cr iteria assignments overlap, the last
assignment applies in the overlap region.
18.51–1
ABAQUS Version 6.1 Module:
ID:
Printed on: