Two-Way Radio User Manual

*
INITIAL CONDITIONS
No data lines are required for TYPE=PRESSURE STRESS, FILE=file, STEP=step, INC=inc.
Data lines for TYPE=RATIO if the USER parameter is omitted:
First line:
1. Node set or node number.
2. First value of void ratio.
3. Vertical coordinate corresponding to the above value.
4. Second value of void ratio.
5. Vertical coordinate corresponding to the above value.
Omit the elevation val ues and the second void rati o value to define a c onstant void ratio distribution.
Repeat this data line as often as necessary to define void ratios at various nodes or node sets.
No data lines are required for TYPE=RATIO, USER.
Data lines for TYPE=REF C OORD INATE:
First line:
1. Element num ber.
2. X-coordinate of the first nod e.
3. Y-coordinate of the first node.
4. Z-coordinate of the first node.
5. X-coordinate of the second node.
6. Y-coordinate of the second node.
7. Z-coordinate of the second node.
Second line:
1. X-coordinate of the third node.
2. Y-coordinate of the third node.
3. Z-coordinate of the third node.
4. X-coordinate of the fourth node.
5. Y-coordinate of the fourth node.
6. Z-coordinate of the fourth node.
Repeat this pair of data lines as often as necessary to define the reference mesh in various elements.
The order of the nodal coordinates must be consistent with the element connectivity.
9.18–11
ABAQUS Version 6.1 Module:
ID:
Printed on: