Two-Way Radio User Manual

*
INITIAL CONDITIONS
Subsequent lines (only needed if more than seven solution-dependent state variables exist in the model):
1. Value of eighth solution-depe ndent state variable.
2. Etc., up to eight solution-dependent state variables per line.
It may be necessary to leave blank data lines for some elem ents if any other element in the m odel
has more solution-dependent state variables because the total number of variables that ABAQUS
expects to read for any element is based on the maximum num ber of solution-dependent state
variables for all the elements in the model. These trailing initial values will be zero and will not be
used in the analysis. Values given on the data lines will be applied uniformly over the element.
Repeat this set of data lines as often as necessary to define initial values of solution-dependent state
variables for various elements or element sets.
Data lines for TYPE=SOLUTION, REBAR:
First line:
1. Element number or elem ent set label.
2. Rebar name. If this field is left blank, the solution-dependent state variable s are applied to all
rebars in these element s.
3. Value of first solution-dependent state variable.
4. Value of second solution-dependent state variable.
5. Etc., up to six solution-dependent state variables.
Subsequent lines (only needed if more than six solution-dependent state variables exist in the model):
1. Value of seventh solution-dependent state variable.
2. Etc., up to eight solution-dependent state variables per line.
It may be necessary to leave blank data lines for some elem ents if any other element in the m odel
has more solution-dependent state variables because the total number of variables that ABAQUS
expects to read for any element is based on the maximum num ber of solution-dependent state
variables for all the elements in the model. These trailing initial values will be zero and will not be
used in the analysis. Values given on the data lines will be applied uniformly over the element.
Repeat this set of data lines as often as necessary to define initial values of solution-dependent state
variables for various elements or element sets.
No data lines are required for TYPE=SOLUTION, USER.
Data lines for TYPE=SPECIFIC ENERGY:
First line:
1. Element number or elem ent set label.
9.18–13
ABAQUS Version 6.1 Module:
ID:
Printed on: