User Manual

19
21. When satisfied with motor or engine installation, mount the cowl using
supplied M3 hardware installed through holes in the F1 former into blind nuts
in the cowl. There is one additional cowl bolt on the bottom.
Horizontal Stabilizers
22. Prepare and install the elevator control horns as previously done with the
aileron control horns. Also install elevator hinges the same as the ailerons.
Note, there are shorten hinges at the inboard location of the elevator to allow
clearance of the stab tube and control horn. See picture below for reference.
Mount elevator servos inside stabilizers as shown. Mount the EF 2 inch servo
arm and complete elevator pushrod assembly. Be sure both elevator push rods
are equal length. The stabilizers mount to the fuselage with one carbon fiber
tube and two M3 bolts (per side).