User Manual

Items needed for completion:

• Masking tape.

• Hobby knife with #11 blades.

• Thin and medium CA. We highly recommend Mercury M5T thin and M100XF

medium formulas as well as the Mercury glue tips.

• 30 minute epoxy. Pacer Z-poxy is a long time favorite.

• Pacer Formula 560 Canopy Glue

• Blue Loctite.

• Electric drill with an assortment of small drill bits.

• Flat head and Phillips head screw drivers.

• Standard and needle nose pliers.

• Side cutters.

• Metric ball driver or allen key set.

• Sanding block and sandpaper.

• 5 x METAL GEARED servos with a minimum of 400 oz/inches of torque. MKS

HV777A+ or HBL 380 recommented

• Extreme Flight aluminum servo arms: 2 x 1.5 inch arms for aileron, 2 x 2 inch

arms for elevators and 1 x 4" dual arm for the rudder.

• 2 x 12” Servo Extensions for the Ailerons.

• 1 x 12” Servo Extension for throttle or ESC

• 2 x 48” Servo Extensions for the elevator.

• Xpwr 60cc brushless outrunner motor

• Blazing Star Standard XL standoff kit for electric motor mounting

• Castle Creations 160 HV ESC.

• Receiver battery

• 2 x 6S 5000-5500 mah LiPo battery hooked up in series for 12S operation

• Xoar 24 x 12 PJN electric prop.

• DA-70 with mufflers if using a gas engine.

• Blazing Star DA 70 stand off.

• Flowmaster 17 or 24 oz. fuel tank.

• EF 4.5" CARBON FIBER spinner with aluminum backplate.