User Manual

ManualsBrands3d hobby shop ManualsAircraftsExtra 300 SHP V3 (Blue White Black)

Table Of Contents

Assembly Manual / Airframe – 47” Extra SHP
Control Throws and Exponential
- Setting appropriate control throws is a critical step in matching your model to your flying style. Personally, I use two different flight “modes”– precision and 3D. Depending upon your radio, you may be able to combine all three dual rate functions onto a single switch, which is the technique I use. Regardless, be sure to use a common assignment scheme to prevent being in the wrong rate at the wrong time. I prefer my switches to be higher for high rates and lower for low rates, but virtually any combination will work – just be comfortable with your setup.

Install tailwheel bracket with two small wood screws. Check for free swinging of

rudder. Adjust bracket

as necessary to allow rudder to swing freely. Install tailwheel

and tighten tailwheel collar with 1.5mm allen wrench.

Locate the 4 control horns in your kit. The three on the left are for the elevator and ailerons. The

double control horn is for the rudder.

Note: if installing the rudder servo in the aft position (for push-pull), you may cut off one side of the rudder

control horn. Otherwise, install the double control horn for pull-pull installation.