User Manual

Remove the covering over the slot in the rudder on the RIGHT side as shown, apply a generous
amount of medium CA into the slot and onto the bottom of the control horn. Insert horn into slot fully
as show and allow to cure.
Pushrod connectors – The pushrod connectors attach to the servo arm with a nut, as shown. When
you install these pushrod connectors, do not tighten the nut all the way, the connector must be free to
rotate. Place a drop of medium CA on the end of the nut and apply CA accelerator to lock it to the
threads. You must lock the nuts on your servo connectors, otherwise the nuts will vibrate loose and
your plane will crash.
On the HS-65 servo stock arm, you must open the diameter of the hole in the servo arm for the pushrod
connector, use a drill bit or you can rotate the point of a hobby knife in the hole to open it.
Make sure your connectors rotate freely after installation.
Attach servo extension onto rudder servo, use tape or a commercial servo plug lock to be sure that the
extensions does not become unplugged in flight. Using servo mounting screws which come in the
servo package, install the rudder servo as shown.