User Manual

Table Of Contents

Install elevator horn, servo, arm, and pushrod on the LEFT side of the aircraft using the same

procedure as the rudder components. The elevator pushrod is the 2

longest in your kit. The

elevator pushrod will require a slight bend near the servo for alignment.

Assemble your brushless motor for mounting *in front of* the firewall (many brushless motors have more

than one mounting option). Mount the motor to the firewall as shown using the 4 longer 3mm allen-

head screws in your kit. If you are using the recommended motor, you will need to use the 4 white

nylon motor spacers included in your kit. Use blue Loctite on these screws.

Attach your speed controller to the side of the motor box with plastic Zip-ties or Velcro

The motor and the speed control are connected together with 3 wires. If you need to reverse the

direction of rotation of your brushless motor, disconnect and switch any two of these wires.

NOTE: NEVER RUN YOUR MOTOR WITH A PROP INSTALLED INDOORS OR ON YOUR

WORKBENCH. DO NOT INSTALL YOUR PROP UNTIL YOU ARE PREPARED FOR AN OUTDOOR

TEST.

Install your receiver onto the receiver mount in the fuselage as shown using Velcro or a Zip-tie.