User Manual

ManualsBrands3d hobby shop ManualsAircraftsExtra 300 SHP V3 (Blue White Black)

1

2

3

4

5

6

7

8

9

Table Of Contents

Assembly Manual / Airframe – 47” Extra SHP
Control Throws and Exponential
- Setting appropriate control throws is a critical step in matching your model to your flying style. Personally, I use two different flight “modes”– precision and 3D. Depending upon your radio, you may be able to combine all three dual rate functions onto a single switch, which is the technique I use. Regardless, be sure to use a common assignment scheme to prevent being in the wrong rate at the wrong time. I prefer my switches to be higher for high rates and lower for low rates, but virtually any combination will work – just be comfortable with your setup.

Place wheel on aluminum wheel axle and install aluminum wheel collar, using a 1.5mm

allen wrench to tighten the set screw.

Place wheel and axle assembly inside wheel pant. Attach wheel/pant assembly to carbon landing gear as

shown using locking nut. NOTE: The locking nut will be difficult to tighten since it is a locking design.

Use a pliers to hold the wheel collar and a nut driver or wrench to turn the nut.