User Manual

ManualsBrands3d hobby shop ManualsAircraftsExtra 300 SHP V3 (Blue White Black)

1

2

3

4

5

6

7

8

9

Table Of Contents

Assembly Manual / Airframe – 47” Extra SHP
Control Throws and Exponential
- Setting appropriate control throws is a critical step in matching your model to your flying style. Personally, I use two different flight “modes”– precision and 3D. Depending upon your radio, you may be able to combine all three dual rate functions onto a single switch, which is the technique I use. Regardless, be sure to use a common assignment scheme to prevent being in the wrong rate at the wrong time. I prefer my switches to be higher for high rates and lower for low rates, but virtually any combination will work – just be comfortable with your setup.

Insert carbon wing tube into fuselage. Measure from tube to horizontal stabilizer on both sides of

fuselage.

Equalize measurements to square the stabilizer.

Drip thin CA glue into the stabilizer-fuselage joint. Do not remove any covering from the

horizontal stabilizer.