User Manual

ManualsBrands3d hobby shop ManualsAircraftsExtra 300 SHP V3 (Blue White Black)

1

2

3

4

5

6

7

8

9

Table Of Contents

Assembly Manual / Airframe – 47” Extra SHP
Control Throws and Exponential
- Setting appropriate control throws is a critical step in matching your model to your flying style. Personally, I use two different flight “modes”– precision and 3D. Depending upon your radio, you may be able to combine all three dual rate functions onto a single switch, which is the technique I use. Regardless, be sure to use a common assignment scheme to prevent being in the wrong rate at the wrong time. I prefer my switches to be higher for high rates and lower for low rates, but virtually any combination will work – just be comfortable with your setup.

Apply medium CA into the slot in fuselage and install vertical stabilizer.

Drop a few drops of thin CA onto the elevator joiner rod at the factory joint of elevator and rod. Allow to soak

in for a few minutes, then wipe off excess.

Install elevator half with joiner rod onto horizontal stabilizer, sliding hinges into slots in stabilizer DO NOT

GLUE

HINGES YET. Apply a generous amount of medium CA into joiner slot on second elevator.