User's Manual
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Unpacking
- Chapter 3. Setting Up
- Chapter 4. Operating
- Chapter 5. Symbols
- Chapter 6. Warranty and Repair Service
- Chapter 7. Technical Assistance
User Manual
FireCR
3.5. Connect the Cable and Power Cord
3.5.1. Connect Interface Cable
The scanner interfaces with computer via USB2.0 cable.
1. Use the USB cable in the shipping container.
2. Connect the cable to the scanner’s USB2.0 port, located on the rear of the scanner.
3. Connect the other end of the cable to the USB2.0 port on the computer.
FIGURE 5. USB connection
DANGER
This equipment is indoor use only and all the communication
wirings are limited to inside of the building.
22