User's Manual
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Unpacking
- Chapter 3. Setting Up
- Chapter 4. Operating
- Chapter 5. Symbols
- Chapter 6. Warranty and Repair Service
- Chapter 7. Technical Assistance
User Manual
FireCR
3.5.2. Connect the Power Cord
1. Connect the power cord to the scanner, located on the rear side.
2. Connect the other end of the cord to a grounded power outlet.
FIGURE 6. Power connection
DANGER
This equipment must only be connected to supply mains with
protective earth. Use only a three-wire cord that has grounding.
This is a safety feature. If you are unable to insert the plug into
the outlet, contact your electrician to replace your obsolete outlet.
Do not defeat the safety purpose of the grounding-type plug.
Do not use with any electrical power supply that does not meet the
ratings displayed on the power adapter. Use with any other
power adapter may lead to fire or electrocution.
DANGER
DANGER
Do not use any power adapter and power cord other than the
power adapter and power cord included with the system. Doing
so may lead to fire, electrical shock, or electrocution.
23