User's Manual
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Unpacking
- Chapter 3. Setting Up
- Chapter 4. Operating
- Chapter 5. Symbols
- Chapter 6. Warranty and Repair Service
- Chapter 7. Technical Assistance
User Manual
FireCR
27
4.3. Operating Instructions
4.3.1. Turn on the Scanner
Turn on the scanner. Power switch is on the rear side of the scanner.
4.3.2. Turn on the Computer
Turn on the computer. Quantor Acquisition and Diagnostic Software must be installed before
operate the scanner.
4.3.3. Cassette Insert and Eject
Insert the cassette to the entrance of the scanner and push gently until it reaches to the
protection wall inside of the scanner. Blue indication LED is on when the cassette is inserted
correctly. Insertion direction of the cassette must be parallel to the scanner.
Cassette can be ejected after scanning and erasing when blue indication LED is on. Gently
pull back the cassette and ejection direction of the cassette must be parallel to the scanner.
4.3.4. Getting a Scanned Image
To getting a scanned image, refer to Quantor Acquisition and Diagnostic Software manual.
DANGER
This device uses laser. Avoid looking inside of the scanner.
WARNING
Do not insert the cassette in wrong direction or upside down when
it is being inserted. Cassette insertion direction is marked on the
cassette.