User's Manual

User Manual
FireCR Dental TM-801-EN
19
3.4. Installation of Acquisition and Diagnostic Software
Refer to Acquisition and Diagnostic Software manual.
3.5. Connect the Cable and Power Cord
3.5.1. Connect USB Interface Cable
The reader interfaces with computer via USB2.0 cable.
1. Use the USB cable inside the shipping container.
2. Connect the cable to the reader’s USB2.0 port, located on the rear of the reader.
3. Connect the other end of the cable to the USB2.0 port on the computer.
Figure 4. USB Connection
D
ANGER
This equipment is indoor use only and all the communication
wirings are limited to inside of the building.
W
ARNING
Do not pull out the USB cable during scanning.