User's Manual

User Manual
FireCR Dental TM-801-EN
20
3.5.2. Connect Ethernet Cable
The reader interfaces with computer via Ethernet cable (RJ45 CAT.6 UTP).
1. Connect the cable to the reader’s Ethernet port, located on the rear of the reader.
2. Connect the other end of the cable to the Ethernet port of the Ethernet-hub.
3. If you want to connect to PC directly, use crossed type cable instead of normal Ethernet
cable.
Figure 5. Ethernet Connection
D
ANGER
This equipment is indoor use only and all the communication
wirings are limited to inside of the building.
W
ARNING
Do not pull out the Ethernet cable during scanning.