User Manual
page 16
... print your plane | www.3DLabPrint.com
Now apply glue (marked red in the picture) and assemble together motor mount and engine
gondola, then glue the „sure bonds“ (small triangle parts) in to the joints:
!ANNEALING!
We suggest to anneal the PLA motor mount. You can use this procedure: submerge in boiling
water for more than 30 minutes (pla is then much more heat resistant).
Because PLA shrinks when annealed (about 2%) it is good idea to use motor_mount_annealing
compensated for this eect, or you can adjust the scaling exactly for your PLA brand in
Simplify3D or any other slicer:
Continue with R and L motor mount, note: for proper function there is angle compensation
for propeller slipstream so right orientation is essential, see the pictures below):