User Manual

page 15
... print your plane | www.3DLabPrint.com
6. R/C equipment
6.1 motor setup
HIGH PERFORMANCE SETUP (if you like it hot, yeah)prop 9/6, 9/7 fast:
See video guide #6 (for HP setup)
you will need: Motor – AX-4008Q-620KV
Speed controler (ESC) – CC Talon 25 or similar 25A/6s
3x PAIRS, 3.5mm Gold Connectors - optional
Battery 1300mAh/6s – or 2x 1300/3s (use 2to1 serial connector)
Male XT60 connector
Shrink Tube black
Solder wire and Soldering Iron
Hands free Holder - optional
printed motor mount (25/25)
ECO PERFORMANCE SETUP(spent only 30 bucks without any soldering)prop 9/6 10/5:
you will need: Turnigy D3530/14 1100KV or similar 3530-35 1100kv
30A Electronic Speed Controller or similar 30-40Amps
Turnigy 2200mAh 3S 20C or similar 1500-2400/3s
printed motor mount, find the one which fits... (25/19)
6.2 servos
Test and center all servos with servo tester or transmitter, then instal horns in midle position
and cut wing Servos mount... use HXT900 or any 21x21x23mm
See video guide #7
you will need: 4x 9g Servo HXT900
2x Servo Lead Extension or similar
Snap knife
Soldering Iron or Small handsaw or Dremel