User Manual

page 15
... print your plane | www.3DLabPrint.com
6. Servo and pushrod installation
Install servos to fuselage servo bays. Use a 0,6-0,8mm steel wire with L bends as a linkage
between the servos and elevator/rudder control horns.
See video guide #7
you will need: 2x HXT900, or opt1, opt2, opt3 or any similar
23x12x26 mm / 0.74x0.42x0.78 inches
0,6-0,8 mm steel wire for elevator and rudder pushrod
Snap knife, pliers
7. Motor & ESC
Mount the motor using small self-tapping screws to the printed universal motor holder. For
long motors you can flip the holder to the front. Connect ESC and check rotation. Insert
universal motor mount with motor into the fuselage in right position and secure with two
screws.
See video guide #8
you will need:
6x 1.5/10self-tapping screws
soldering Iron, shrink tube...
Motor Setup
Motor: any 10-30grams, 28-05, 2800KV, opt1, opt2, opt3... or similar
+ suitable propeller holder (if not included)
ESC: any 12A/2s, opt1, with caution opt2 or similar
Propeller: two blade GWS 5 x 3 (ugly orange) or opt1, opt2 (use CCW)
Battery: 350mAh/2s, opt1, opt2, opt3, opt4,
Batt. connector: JST + shring tube