User Manual

page 16
... print your plane | www.3DLabPrint.com
8. Final assembly/setting
See video guide #9
you will need: Your own Rx/Tx system
Rubber Band (thiny)
Refer to your R/C system userguide for setup information.
Install your reciever, connect battery, setup servos and etc. with your trasmitter, check servo
position, then install propeller, and spinner.
Never set ESC with propeller installed, this could be very dangerous!
9. Go flying
Pre-flight check center of gravity is very important, battery properly charged, rudder and
elevator deflection check, calm weather (wind under 5km/h, 3mph) ...
Bungee Prop -Flyght video
elevator rudder
+6mm
+10mm
-4mm -10mm