User Manual

page 15
... print your plane | www.3DLabPrint.com
5. Assembly of printed parts
5.1 Wing assembly Ta 152 H
Glue wing parts L1-L6 perfectly together. The new 3DLabPrint lock system will help you.
Repeat for the right side. Glue both halves of the wing together. Use the CA glue, (position
locks and pins will help you to align the parts), and use activator to speed up the glue curing.
On a flat surface glue the ailerons L1-L3 and repeat for the right side. Use a suitable 0,8mm -
1,2mm carbon rod or wire as a hinge for the ailerons. Just slide it in, there‘s no need to glue
the hinge for easy aileron or servo replacement.
See video guide #4
you will need: CA Glue medium viscosity+ activator
0,8 - 1,2 mm carbon or steel wire for aileron hinge
Snap knife, Some cloth for wiping CA glue...
wing L1
57g/2.01oz
wing L2
42g/1.48oz
wing L3
24,5g/0.86oz
(12,3g/0.43oz) LW
wing L4
14g/0.49oz
(7g/0.24oz) LW
wing L5
2g/0.07oz
(1g/0.04oz) LW
aileron L1
5,4g/0.19oz
(2,7g/0.09oz) LW
aileron L2
12,3g/0.43oz
(6,15g/0.21oz) LW
aileron L3
5,9g/0.20oz
(2,9g/0.10oz) LW
R wing completed