User Manual

page 20
... print your plane | www.3DLabPrint.com
8. Final assembly and setting
Refer to your R/C system userguide for setup information.
See video guide #8
you will need: Your own Rx/Tx system
Install your reciever, connect battery, setup servos and etc. with your trasmitter, check servo
position, then install propeller.
Make sure the battery is positioned properly and secured with wing battery holder, if battery
moves during flight it can shift the center of gravity backwards and aircraft will become
uncontrollable! Never set ESC with propeller installed, this could be very dangerous!
9. Go flying
Pre-flight check center of gravity is very important (move it 5-10mm forward for the first
flights), battery properly charged, ailerons and elevator deflection check, your own flying
skills or RC simulator training ...
Fly video of Ta 152 H
aileron elevator
+15mm
+15mm
-12mm -15mm