User Manual

page 3
... print your plane | www.3DLabPrint.com
General specifications (HP setup):
Wingspan: 1236 mm / 48.2 inch
Lenght: 870 mm / 33.9 inch
Height: 178 mm / 6.95 inch
Wing area: 21,4 dm2 / 2.28 square foot
Wing loading: 46 g/dm2 / 15.3 oz/square foot
Center of gravity: 60 mm / 2.34 inch
from leading edge
Airfoil: LHK508 modified by 3DLabPrint
Print weight: 624 g / 22.01 oz
Print weight of hybrid version: 490 g / 17.31 oz
Empty weight (w/o battery): 680-890 g / 24-31 oz
Takeo weight (6s 1500 lipo): 810-1190 g / 28-42 oz
Max takeo weight: 1300 g / 46 oz
Never exceed speed, VNE: 150 km/h / 93 mph
Design maneuvering speed, VA: 100 km/h / 62 mph
Stall speed, VS: 30 km/h / 18.6 mph
Recommended setups
Motor: EMAX MT 3510 600KV (for 6S setup)
DYS D4215 650KV (for 6S setup)
AX-4008Q 620KV (for 6S setup, motor is discontinued
- use it from your old planes)
ESC: YEP 40A/6S or similar
Propeller: two blade APC electro 10 x 5,5 or Aeronaut CAM Carbon Light 10 x 6
Battery: Li-Pol 1500-1800mAh 6S1P Battery Pack
printed PET motor mount with alluminium cross mount
More tested setups you can find at page 19.
Performance measurement
Max speed VH (level flight): 105 km/h – 56.7kn – 65.2mph with APC 11x5,5
Rate of climb: 20 m/s (5 373 ft/min) with APC 11x5,5
Flight time (6s 1700mAh/full): 7:30 with APC 10x5,5