Owner manual

ManualsBrands3D Robotics ManualsHardwareRTF Aero OSD

RTF AERO FPV/OSD KIT

AV receiver

Antenna

Two 900 mAh

LiPo batteries

Thank you for purchasing a OSD/FPV Kit with your RTF Aero!

Your new, lightweight video setup allows you to capture onboard video from the

Aero using a compact camera, overlay the video with important data from your

autopilot, and transmit the video in flight. This kit does not include a device to view

your video. Please see the section on page 4 for different options for viewing

the video transmitted by your kit.

Wire and power receiver

Attach an antenna to the receiver. Connect the AV output cable to either receiver

AV OUT port. Connect the RC power cable to the receiver DC IN port, and attach

a battery to the red connector.

Receiver cables

Summary of content (5 pages)

PAGE 1
RTF AERO FPV/OSD KIT AV receiver Receiver cables Antenna Two 900 mAh LiPo batteries Thank you for purchasing a OSD/FPV Kit with your RTF Aero! Your new, lightweight video setup allows you to capture onboard video from the Aero using a compact camera, overlay the video with important data from your autopilot, and transmit the video in flight. This kit does not include a device to view your video. Please see the section on page 4 for different options for viewing the video transmitted by your kit.
PAGE 2
Mount and connect transmitter battery Open the FPV compartment in the nose of the Aero. Mount the battery to the velcro strip, and connect the red connectors to power the FPV transmitter. camera The FPV camera is located in the nose of the plane. OSD Configuration To learn more about your MinimOSD or to change the configuration and settings of your video display, visit the APM:Plane wiki pages here.
PAGE 3
Charging the batteries Connect charger to the power adapter cable and a wall outlet. Connect the red cable to the + port and the black cable to the - port. + – Set the charger to LiPo and 1A. LiPo 1A Connect the white battery connector to the 3S port, and connect the XT60-JST charger adapter to the red battery connector and yellow charger connector. 3S port LIPO 1A Secure battery inside the guard bag while charging. Charge until the status indicator displays green.
PAGE 4
Battery information The transmitter and receiver are powered by 3-cell 11.1 V 900 mAh lithium polymer (LiPo) batteries. Please charge the batteries before each use. Each full battery provides approximately two hours of operation for your OSD/FPV system. Protect battery from extreme heat, extreme cold, puncturing, and flammable surfaces. Charge battery using a designated LiPo balance charger only. Always monitor battery while charging, and always fly with a fully charged battery.
PAGE 5
Receiver specifications »» »» »» »» »» »» »» 5.8 GHz Wireless AV Receiver Receiving Frequency: 5705-5945 MHz / 8 CH Receiving Sensitivity: -90 dBm Antenna connector: RP-SMA Power supply voltage: DC 7-12V Supply current: 150 mA Dimension: 61*52*13 mm Camera specifications »» »» »» »» »» »» »» »» »» »» »» »» »» »» »» »» »» Image device: 1/3” Sony Super HAD Color CCD Horizontal resolution: 520 TV line. Minimum illumination: 0.