Circuit diagram

3Dsimo Kit
Device: 3Dsimo Kit
Rev. 1.00 Page 7/18
4.2 Setting up the IDE
Before the first compilation, it is necessary to choose the right development board - Arduino Nano at
Tools => Board => Arduino Nano , as shown in Pic. 4. The next step is choosing the right processor.
Our board is shipped with ATmega168, which you have to choose as in Pic. 5. After selecting the right
board, you need to select the appropriate port, COM3 in our case as seen on Pic. 6.
Pic. 4: Choice of the development kit(Arduino Nano)
Pic. 5: Choice of the right processor(ATmega168)