User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
83D Systems, Inc.
6
UNPACKING AND SETTING UP YOUR CUBEPRO
CONTENTS
*The number of cartridges depends on the ordered conguration.
NOTE: The appearance of some components may vary.
Wire Cutters Print Pad Cleaner
(scraper)
Needle Nose
Pliers
Wrench
(8 mm)
SandpaperHex Drivers
(2.5mm, 3mm and
4mm)
T-Handle
(T10 Torx)
Toolkit USB Stick
Cubify Invent License
Code
Material cartridge* Jet Wiper Power cordPrint padCubePro printer Cube® Glue (x2)