User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
93D Systems, Inc.
UNPACKING AND SETTING UP YOUR CUBEPRO
CAUTION: Due to the size and weight of the printer, this procedure may require more than one person. Ensure
there are enough people to safely and comfortably move the printer to its nal location.
NOTE: Ensure that you save all foam and packing material for the future repacking of your CubePro. Transporting
the printer without original packing materials may damage the printer.
1. Carefully cut the straps (A) if applicable and then pull the tabs (B) on all four
release clips.
NOTE: There is one release clip on each side of the box.
2. Pull the handles (A) and remove the release clips from the outer box.
3. Lift the box away from the printer.
B
A
A