User Guide

113D Systems, Inc.
8. Unpack the top layer of the accessories tray.
NOTE: Depending on the printer conguration, the arrangement
of the accessory boxes may differ. Unpack the power cord (A),
the spacer (B), material cartridge, tool kit and Cube Glue(C). Your
conguration may include 1, 2 or three cartridges. For congurations
with fewer than three cartridges included, empty boxes may be used
as spacers.
9. Unpack the bottom layer of the accessories tray.
NOTE: Depending on the printer conguration, the arrangement of
the accessory boxes may differ. Unpack the print pad (A), the jet
wiper assembly (B), and material cartridges (C). Your conguration
may include 1, 2 or 3 cartridges. For congurations with fewer than
three cartridges included, empty boxes may be used as spacers.
CAUTION: The print pad is fragile. Exercise caution when handling
the print pad.
10. Open the front door. Cut away the zip ties (A) and remove the foam tubing from
the print jet area.
NOTE: For a illustration purposes only, the door was removed from
the image. Do not attempt to remove the door from the printer.
11. Loosen and remove the four (4) 4mm screws securing the Z-Axis guard and
remove the guard. Save the guard and screws for future repacking.
A
B
C
C
A
B
C
C
A