User Guide

Table Of Contents

123D Systems, Inc.

12. Using a 4mm hex head driver, attach the mounting posts to the jet wiper

assembly with the supplied screws and washers.

NOTE: Tighten the screws until the posts are secure.

CAUTION: Do not over-tighten the screws. The jet wiper assembly

can break if the screws are over-tightened.

13. Move the jet wiper assembly to the back of the printer and locate the keyhole

slots (A).

14. Mount the jet wiper mounting posts to the back panel of the printer through the

keyhole slots.

NOTE: Slide the mounting pins downward.

15. Align the jet wiper assembly bottom tab (A) with the slot in the oor (B) and slide

the jet wiper assembly downward.

NOTE: If the jet wiper assembly is fully seated into the keyhole

slots but the bottom does not rest on the thumbscrew head, remove

the jet wiper and turn the thumbscrew counter-clockwise until the

jet wiper bottom rests on the thumbscrew head and the keyhole

slots are fully seated. This may require repeated removals and

re-installations of the jet wiper. If the keyhole slots will not seat,

the thumbscrew may need to be adjusted downward by turning

clockwise.

NOTE: Refer to the section titled Adjusting the Jet Wiper Assembly

for information about adjusting the jet wiper scraper height.

16. Remove the print pad from the box and place it onto the print platform with the

round magnet on the bottom of the pad inserted into the triangular opening on

the platform. Ensure the print pad is securely seated on the print plate.