User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
133D Systems, Inc.
17. Connect the power cord to the power inlet port (B) on the right side of the printer
and the other end to a wall outlet. Press the power on/off switch (A) to power on
the CubePro.
18. Press the on/off button (A) beside the LED screen to power on the CubePro
touchscreen display.
19. Press the touchscreen to navigate to the main menu.
NOTE: Turning on the touchscreen will also turn on the interior LED
lights.
A
A
B