User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
153D Systems, Inc.
NOTE: Connection to a network is conrmed when a checkmark
appears to the left of the network name. If the network is secured, a
lock icon will appear to the right of the network name.
4. Select the checkmark to continue the warranty activation process.
5. Log in to Cubify.com. Go to www.cubify.com, select My Cubify and log in to
your account.
NOTE: You must be logged in to www.cubify.com to activate your
printer. If you have not activated an account, select SIGN UP and
enter the appropriate information.
6. Navigate to www.cubify.com/en/CubePro/Activate.
NOTE: The serial number of your printer will appear on the printer’s
touchscreen display. Take note of the serial number. You will need
it to activate your printer. The serial number can also be found on
a label adhered to the right side of the printer near the power on/off
switch.
7. Select the checkmark to continue.
NOTE: This illustration provides an example of a serial number. Do
not use this number to activate your printer.