User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
173D Systems, Inc.
11. To install cartridges and perform a test print, select START.
NOTE: Install the cartridge in cartridge bay 1 on the left side of the
printer.
12. Open the packaging and remove the thumbscrew from the new cartridge. Select
the checkmark to continue.
13. Pull out 12”/30 cm of material from the material cartridge. Select the checkmark
to continue.
14. Cut off 2”/5 cm of print material from the end. Select the checkmark to continue.
NOTE: Ensure the material is not bent or creased. If the material is
not straight, pull out the damaged material from the cartridge. Cut
off and dispose the portion that is not straight.
15. Insert the print material under the cartridge clamp roller of cartridge bay 1 and
into the material tube. Select the checkmark to continue.