User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
183D Systems, Inc.
16. Continue to manually feed the print material through the material tube until
it begins to extrude from print jet 1 into the jet wiper assembly. Select the
checkmark to continue.
NOTE: When the material reaches far enough into the extruder, the
extruder motor will assist with feeding the material further into the
print jet.
17. (1) Push the front of the cartridge into place. (2) Then, push the cartridge handle
downward until the cartridge is fully seated in its cartridge bay mount. Select the
checkmark to continue.
NOTE: Ensure the front of the cartridge (A) where the material exits is
seated under the clamp roller and between the vertical alignment pins
in the cartridge bay.
18. To continue with the test print, select PRINT.
NOTE: If the test print le uses a color that is not installed in the
printer, select the checkmark to enable the printer to change the
color of the print to a color currently installed.
1
2
A