User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
203D Systems, Inc.
MENU OVERVIEW
Touchscreen Display
After powering on the printer and turning on the touchscreen display, touch the
display to continue.
CAUTION: When using the touchscreen, use only light nger
pressure to make selections. Using anything sharp will damage the
touchscreen display and will void the manufacturer’s warranty.
Print / Setup
PRINT allows the user to print a creation stored either on a USB mass storage
device or from the CubePro software. You can invent your own creation by using
Cubify Invent software available at www.cubify.com.
SETUP allows the user to congure the printer, connect to a wireless or ad hoc
network, install cartridges, or view the printer status.
Navigation
Navigation between screens is performed by pressing the right or left arrows.
Materials
CARTRIDGE STATUS allows the user to view the type and color of the material that
is installed. It also displays the estimated amount of material left in the cartridge.
Selecting CHANGE CARTRIDGE allows the user to install cartridges in empty bays
or replace installed cartridges.
Print Plate Calibration
MOVE JETS allows the user to manually move the print jets in the X and Y
directions.
LEVEL PLATE is a utility that assists in leveling the print pad to the print jets.