User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
223D Systems, Inc.
INSTALLING A MATERIAL CARTRIDGE
Before the printer will print a creation, the correct type of cartridge(s) must be installed in the printer. If the printer recognizes that no
cartridge has been installed, the display will prompt you to install the appropriate cartridge.
1. Select CHANGE CARTRIDGE from the SETUP menu.
2. Select the cartridge to be installed.
NOTE: The print jet will begin to heat.
3. Open the packaging and remove the thumbscrew from the new cartridge.
Select the checkmark to continue.