User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
233D Systems, Inc.
4. Pull out 12”/30 cm of material from the cartridge. Select the checkmark to
continue.
5. Cut off 2”/5 cm of material from the end. Select the checkmark to continue.
NOTE: Ensure the material is not bent or creased. If the material is
not straight, pull out the damaged material from the cartridge. Cut
off and dispose the portion that is not straight.
6. Insert the material under the clamp roller and into the material tube. Select the
checkmark to continue.
7. Gently push the print material into the print jet until print material extrudes into
the jet wiper. Select the checkmark to continue.
NOTE: When the material reaches far enough into the print jet area,
a motor will assist with feeding the material into the print jet.