User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
253D Systems, Inc.
7
PRINTING YOUR CREATION
There are many 3D creations available at www.cubify.com. In addition, you can create your own with the included Cubify Invent
software. For more information about converting a .stl le into a .cubepro le which the printer can use, refer to the section titled
CubePro Software.
PRINTING PROCEDURE
The following steps illustrate how to print a creation.
1. After powering up your printer and turning on your display, press the
touchscreen to begin.
2. Select PRINT.
NOTE: If the le is saved on a USB mass storage device, insert the
device into the USB port on the printer.
NOTE: You can also print directly from the CubePro software using a
wireless connection.
3. Using the arrows, navigate to your le and select PRINT.
NOTE: The le name will be displayed at the top.
NOTE: If the print le requires PLA material and ABS material is
installed, the printer will prompt you to change the cartridge(s). Select
CHANGE CARTRIDGE and refer to the section titled Replacing A
Material Cartridge.