User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
263D Systems, Inc.
NOTE: If the print le requires ABS material and PLA material is
installed, the printer will prompt the user to change the cartridge(s).
Select CHANGE CARTRIDGE and refer to the section titled Replacing
A Material Cartridge.
NOTE: If the print le requires ABS material but PLA is installed,
the printer will prompt you to change the material cartridge. Select
CANCEL and follow the instructions in the section titled Replacing A
Material Cartridge.
NOTE: If there is not enough material in the cartridge to complete the
print, the printer will prompt the user to replace the cartridge. Select
CHANGE CARTRIDGE and follow the instructions in the section titled
Replacing A Material Cartridge.
NOTE: If the creation le uses color(s) that are not installed, selecting
the checkmark will enable the printer to change the color of the print
to a color currently installed. You can also change the cartridge by
selecting BACK and following the CHANGE CARTRIDGE instructions.
To change the cartridge, refer to the section titled Replacing A
Material Cartridge.