User Guide

273D Systems, Inc.
4. Apply two (2) thin layers of glue to the center of the plate. Select the checkmark
to continue.
NOTE: For more information, refer to the section titled Applying
Cube Glue.
NOTE: For small print le sizes, use a light coating of glue. For
larger parts, a slightly thicker coating of glue is recommended.
When the printer begins to print, the glue surface should be mostly
dry. The temperature from the print material will melt the surface of
the glue increasing its adhesion.
NOTE: Ensure that the area where glue is applied is larger than the
base of your creation.
NOTE: The estimated time to completion is noted at the bottom of
the screen.
NOTE: When printing with ABS material, the print chamber will need
to build and maintain a predetermined temperature. Ensure the top
cover and the back panel have been installed. The front door must
be closed.
NOTE: When printing with PLA only or both PLA and ABS material,
the print chamber will not need to be preheated.
NOTE: The print jets required for the print job will begin to heat.
CAUTION: Do not touch the print jets until they have cooled to room
temperature.
NOTE: The blue bar at the top is a progress indicator. Select PAUSE
to temporarily stop printing. Select CANCEL if you wish to cancel
the print job.