User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
333D Systems, Inc.
9
CUBEPRO SOFTWARE
CubePro software is an easy-to-use tool that simplies the printing process. The software is available by logging in to your www.cubify.
com account. Downloads are available for Windows and Mac operating systems.
INSTALLING WINDOWS SOFTWARE
1. Go to www.cubify.com and log in with your username and password.
2. Navigate to www.cubify.com/en/CubePro/Activate. Select DOWNLOAD
SOFTWARE and then select Windows.
3. Select Run to run the installer le.
4. Read through the End-User License Agreement. If you accept the terms of the
agreement, select the acceptance checkbox and select Next.
NOTE: The software will begin to install.