User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
343D Systems, Inc.
NOTE: The software installation is complete.
INSTALLING MAC SOFTWARE
1. Go to www.cubify.com and log in with your username and password.
2. Navigate to www.cubify.com/en/CubePro/Activate. Select DOWNLOAD
SOFTWARE and then select Mac.
3. Select the Downloads icon on the Dock and select the CubePro .dmg le.
4. Drag the CubePro le into the Applications folder.