User Guide
Table Of Contents
-  Introduction
-  Important Safety Information
-  CubePro 3d Printer Features and Benefits
-  At a Glance
-  Specifications and Requirements
-  Unpacking and Setting up Your CubePro
-  Printing Your Creation
-  Finishing Your Creation
-  CubePro Software
-  Operation Procedures
-  CubePro Maintenance
- Restoring Roughness to the Print Pad
- Cleaning the Jet Wiper
- General Cleaning
- Adjusting the Jet Wiper Assembly
- Calibrating the Print Pad
- Calibrating the Z-Gap And Print Pad Level
- Calibrating the Offset Jets
- Calibrating the Wipe Function
- Testing the Print Jets and Extruders
- Moving the Print Jets
- Updating the CubePro Firmware
- Replacing Fuses
- Lubricating The Bearing Rods
- Error Codes
- Contacting Support
-  Cubify Sustainability Program
353D Systems, Inc.
CUBEPRO SOFTWARE OVERVIEW
CubePro software enables the user to import .stl creation les, specify the material type and color, and then orient, scale, size and
rotate the models. Before the printer can print a le, the software must slice it into layers during the build process. This process converts
a .stl le to a .cubepro le which is the le type the printer can print. Once a .cubepro le has been generated, this print le can no
longer be edited although the original .stl le can be used again to create another .cubepro le.
STL Files: Files that can be imported and edited prior to building a .cubepro le.
CUBEPRO Files: Files that have been prepared, sliced into layers, and are ready to print.
NOTE: The CubePro software interface for Mac may differ in color from the Windows version but the functionality will be
the same.
HOME TAB
A
Interface Tabs
B
Tool Ribbon
C
Model Size and Position
D
Print Material Conguration
E
Print Pad
A B
C
D
E